Blinder product:

Blinder M27 laser jammer

BLINDER M27 LASER JAMMER INSTALL DETAILS

1. Check Blinder M27 mounting location for support
   • Two self tapping screws mount the Blinder M27 sensor
   • Blinder M27 sensors are 4" Wide by 2" Deep by .5" Height

2. Mount 2 Blinder M27 sensors in front grill or under bumper
   • Blinder M27 sensors should be installed around 24 inches apart
   • Blinder M27 sensors need an unobstructed view of the road and can not be blocked or installed behind anything
   • Level Blinder M27 sensors parallel to the road and pointing straight ahead
   • Blinder M27 sensors should be balanced out with the center of vehicle and the headlights
   • For states with front license plates, balance out the Blinder M27 sensors between the front license plate and the headlights

3. Route Blinder M27 cables from sensors to the firewall or car door jam
   • Use cable ties to run the Blinder M27 cables along the fender away from the engine

4. Run Blinder M27 cables inside vehicle
   • Look for a grommet to use to route the cables inside the vehicle
   • Unused firewall grommets or door jam grommets can be used

5. Mount Blinder M27 interface under dash in a reachable place so software upgrades can be performed

6. Run positive to Blinder M27 interface
   • If using the free fuse tap supplied with stoplaser.com orders then find the main fuse box in the vehicle and route the positive
   • Route positive to Blinder M27 switch then the positive from the switch to the interface

7. Run negative to Blinder M27 interface
   • A chassey ground can be used and any bare metal surface can be used for the negative

8. Route cable for Blinder M27 audio/visual alerts to interface 
   • Visual LED alert 
   • Audio speaker

9. Plug-in Blinder M27 cables to interface

10. During first startup leave the system on for at least 1 minute for initialization and for software update and then drive free...
   • 0 is off
   • l is parking mode 
   • ll is laser jammer mode 




 Blinder M27 Manual